Stainless steel needle tubing for the manufacture of medical devices. Requirements and test methods1 Scope This International Standard applies to rigid stainless steel needle tubing suitable for use in the manufacture of hypodermic needles and other medical devices primarily for human use. This International Standard provides requirements and test methods for the tubes manufactured for needles as component used in medical devices. Additional performance testing on the tube aspect may be required when the component is incorporated in the ready to

These moulded shapes are normally supplied in the styles and dimensions given in IEC 62329-3- 100

Encouraging responsible resource use

BS EN 55016-1-3 specifies the characteristics and calibration of the absorbing clamp for the measurement of radio disturbance power in the frequency range 30 MHz to 1 GHz

BS EN 114000 specifies the electrical

The purpose of a combined passive infrared and ultrasonic detectors is to detect the broad spectrum infrared radiation emitted by an intruder and

Analogue audio disk records and reproducing equipment manufacturers

The knowledge and practical skills that divers must achieve to reach that level

In compliance with BS EN 9320

BS EN ISO 11806 covers brush cutters as well as grass trimmers

BS EN IEC 60376 on technical grade sulphur hexafluoride is relevant to:

adopted/approved following construction

Scope has been revised by excluding EN 16582