Gas cylinders. Acetylene cylinders. Filling conditions and filling inspection1 Scope This International Standard specifies minimum requirements for the filling conditions and filling inspection of acetylene cylinders. This International Standard is not applicable to an assembly of cylinders connected by a manifold, e. g. bundles (see ISO 13088).

the following changes have been made:

regulator assembly

flow lines

EN 10025:1992

the general process is accepted as being equivalent to subjecting samples of those cables to a voltage test in water

BS EN 12101-10 discusses lifting bag systems for fire and rescue service use

6 mm to 68 mm inclusive

minimize noise and vibration-related inefficiencies and are energy efficient

The setting time is determined by observing the penetration of a needle into the smoothing and/or levelling compound mixture and recording the time for a given penetration value

Greater monetary efficiency within the creative team

as listed in this Technical Report

Toys are required to be accompanied by sufficient information to enable their safe operation