Milling cutters with tenon drive. Interchangeability dimensions for cutter arbors. Metric series1 Scope This document specifies the dimensions for interchangeability between milling cutters with tenon drive and the cutter seating of cutter arbors. It is applicable only to milling cutters of the metric series. It gives the interchangeability dimensions for: the milling cutters; the cutter seating on the arbor; the cutter retaining screw on the cutter arbor.

This document is applicable to non-SOLAS marine evacuation systems

This Part of EN 1677 specifies requirements for forged steel lifting hooks of grade 4 having latch and eye up to 31

Note2: It is not intended that BS EN 60349-4 should apply to machines on small road vehicles

floor-standing equipment and body-mounted equipment

PD CEN/TS 17261 describes a methodology for the evaluation of biometric authentication for AACSs against the specified requirements

Test purposes intend to check the correctness of the application data unit exchange in a different transaction in case the Implementation Under Test (IUT) is the central equipment implementation of the toll charger

lakes and transitional waters

2 Combination of pipes and fittings/valves made of different metals

and ISO/TS 17187 which are transport domain-specific

– Clause 6 gives wireless-specific requirements that have to be included in the system design

Why should you use PAS 64 - Recovery of water damaged buildings

— before or during sea-trial