Kidde GSA-CT1 Vigilant Single Input ModuleKidde GSA CT1 Vigilant Single Input Module is an intelligent analog addressable device used to connect one or two Class B normally open Alarm, Supervisory, or Monitor type dry contact Initiating Device Circuits (IDC). The GSA CT1 is intended for use with the Signature Loop Controller only. The actual function of these modules is determined by the personality code selected by the installer. This code is downloaded to the module from the Signature loop

two-wire detector which uses a dual rate of-rise and fixed-temperature heat sensor to determine when to signal an Alarm condition

control display modules and the eight auxiliary 3

Combining the 4-PPS/M with legacy power supplies will cause damage to the power supply

the fiber option is not available to the 4009 IDNet

Wheelock HNRC Horn

Compatible Devices:

Edwards EST 757-8A-RS70 Speaker Strobe

The Simplex 4098-9791 TrueAlarm Supervised Relay Base is a 4-wire TrueAlarm Sensor Base with connections for Supervised Remote Relay (2098-9737) and for remote LED alarm indicator

no separate power required

and either a network connection*** or a direct connection to the NFS-640 or NFS-3030

The XRM-24 mounts on two studs located in the backbox below the factory installed standard transformer

Refer to Section 3